Lockstate LS-60 Installation Guide Manual de usuario descargar pdf (Pagina 8)

PG 8

HVAC Selection

• Set the HVAC TYPE switch in the NORM position if you have

conventional natural gas, propane, oil, or electric heat. If you

have a HEAT PUMP system set the HVAC TYPE switch to HP.

• Set the HEAT SOURCE switch in the GAS position if you have normal gas or oil heat or if you have

a heat pump with gas or oil auxiliary heat. Put the HEAT SOURCE in the ELEC position if you have

normal electric heat or if you have a heat pump with electric auxiliary heat.

Install 3 AA Batteries

• Install 3 AA alkaline batteries [required] following

the marked polarity in the battery compartment.

Put the lower battery in negative end rst against

the spring, then push the positive end in. Then

insert the last 2 batteries as shown.

IMPORTANT: Press the RESET button (under

top cover) to implement the HVAC switch selections.

• With all the wires connected it is time to turn the AC power back on. Do this at the breaker you used

to switch it off. The LS-60 will power-up in the OFF mode. Your LS-60 is not congured to operate your

HVAC system yet. You must now congure your thermostat for your HVAC system.

AS ELEC

HVAC

TYPE

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Sin comentarios

Lockstate LS-60 Installation Guide Manual de usuario Pagina 8